Keri-systems HPP-100 Instrukcja Użytkownika Pobierz pdf (Strona 46)

HPP-100 Hand-Held Programmer

Revision 3.3 40

Group 0 Commands G / N Key-In Data Parameters

Exit Command Mode n/a 0 SEND

Define a Time Zone G 0 1 [tz#] [start : hh mm] [stop : hh mm] [day code]

SEND

(0-5, 7), hour (00-23), day code (000-127)

Set Anti-Passback N 0 3 [1/2] SEND 1 = ON, 2 = OFF

Set Auto-Unlock Time Zones N 0 4 [tz#] [tz#] SEND (0-5, 7), (0-5, 7)

Memory Module Commands Key-In Data Parameters

Transfer Cards to Memory Module N 0 2 SEND

Transfer Events to Memory Module N 0 5 SEND

Erase Memory Module n/a 0 6 VOID SEND

Set Data File Identifier n/a 0 7 [id#] SEND (000-999)

Erase Events in Memory Module n/a 0 8 SEND

Transfer Cards from Memory Module G 0 VOID [id#] SEND (000-999)

Level Commands Key-In Data Parameters

Configure Serial Port N LVL 9 2 [#] SEND 0 = Printer, 1 = PC, 2 = Modem

Enroll Card by Number Code G LVL 9 4 [card#] SEND (0000000000-9999999999)

Reset Anti-Passback (all cards) G LVL 9 0 SEND

Set Security Fence (for Cards) N LVL 9 6 [slot#] SEND (0000-6999)

Set Daylight Savings G LVL 9 7 [#] SEND 0 = Disabled, 1 = Enabled

Display Favorite Reader List G LVL 9 1 SEND

Transfer Card from Master to FRL G LVL 9 3 [slot#] SEND (0000-6999)

Transfer Cards from Master to FRL G LVL 9 3 [low-slot#] ZIP [high-slot#] SEND (0000-6999)

Add Reader to the FRL G LVL ENRL [rdr#] SEND (1-6)

Add Readers to the FRL G LVL ENRL [rdr#] ZIP [rdr#] SEND (1-6), (1-6)

Remove Reader from the FRL G LVL VOID [rdr#] SEND (1-6)

Remove Readers from the FRL G LVL VOID [rdr#] ZIP [rdr#] SEND (1-6), (1-6)

Master Control Commands Key-In Data Parameters

Change PIN G 9 [old PIN] VOID [new PIN] ENRL [new PIN] SEND (0000-9999), (0000-9999), (0000-9999)

Clear Reader Memory N 0 999 SEND 999 SEND

1 2 ... 41 42 43 44 45 46 47 48

Brak uwag

Keri-systems HPP-100 Instrukcja Użytkownika Strona 46