Keri-systems HPP-100 Instrukcja Użytkownika Pobierz pdf (Strona 7)

HPP-100 Hand-Held Programmer

Revision 3.3 1

The HPP-100 Hand-Held Programmer

The

HPP-100 Hand-Held Programmer

is a powerful and convenient tool, yet its operation is

simple enough for anyone to master in a short period of time. The

HPP-100

has the appearance

of a TV remote control, but has a different principle of operation. It is a mini-transmitter using a

radio frequency (RF) rather than an infrared signal to transmit data. Unlike a television remote

control (that requires a direct line-of-sight between the infrared transmitter in the remote and the

infrared receiver in the television) the

HPP-100

should be held parallel to the proximity antenna

(see Figure 1).

Hand Held

Programmer

Reader

Figure 1 – HPP-100 Orientation

Hold the

HPP-100

within the range of the proximity antenna (approximately 1-foot) and press the

appropriate button to send a command. Allow about 0.5 seconds for a response from the reader.

Point it at the Master Control Reader (within three to four inches of the reader) and press the

appropriate button to send a command. Allow about a half-second for a command response. The

reader’s sound alert will respond to the command with a distinct beep.

Command Response “BEEP” Status

BEEP 1 short Confirms the depression of a key on the

Hand-Held Programmer.

BEEP-BEEP 2 short Confirms acceptance of a complete

command sequence.

BEEEEEEEEP 1 long Confirms rejection or an invalid operation was

attempted.

BEEP-BEEP-BEEP-BEEP continuous short Indicates the door sense switch is open.

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Brak uwag

Keri-systems HPP-100 Instrukcja Użytkownika Strona 7